If it's not scratched or dirty I suggest returning it and get another one due to the manufacturer bad press (burn). Once youve done that, download the hard drive manufacturers diagnostics CD, and a run both the short and the long drive tests. To find the firmware you currently have use Nero Infotool: Following on from Scott, you need to run Memtest86+ first, the crucial bit is that it must run for at least 10 cycles to make sure the memory is 100. Slysoft nor I will be held responsible for anything that goes wrong should you use firmware that is not officially supported by the brand of your burner. The link that's there takes you to the firmware page. try to assign one, or try to find a rpc1 patched firmware. You can try to find a rpc1 patched firmware at 4) Your drive is an rpc2 drive that has not yet been assigned a region. "It is possible the original movie you have has some bad sectors.ġ) DVD media is dirty - you can try to clean itĢ) DVD media is damaged, you have to replace itģ) Your drive is a region locked rpc2 drive, which does not allow reading of scrambled sectors from a different region and try to read a DVD from a different region. If Nero cd-dvd speed reports read errors, your disc is (probably) bad and needs to be exchanged-even if it plays fine (or your optical drive could be slowly dying). Select the appropriate drive letter, and click "start". With Anydvd running in the background, select the tab labeled "scandisc". Why am I getting CRC, TCSectorReader, or read errors in general when Clonedvd tries to read a disc? Click to om Frequently Asked Questions (READ BEFORE YOU POST)ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |